Guard Booth Installation

Mardan Fabrication guard booths, because they are built of aluminum construction are very light in weight. This allows for easy mobility when it comes to offloading and installing the guard booths. When the security booths are shipped from the Mardan production facility, the guard booths are loaded on a flatbed truck allowing for a forklift to get underneath the booth and offload it from the truck. The contractor installing the booth should have a concrete slab prepared for setting the booth onto. The guard booths will have anchor clips as shown on the project specific CAD drawing that is approved by the customer. Usually a minimum of four anchor clips are provided, one at each corner of the booth, but the actual number of anchor points are determined based on the size and location of the guard booth. Once the booth is anchored down to the concrete slab, the customer or their contractor would then connect the onsite power stub-in to the booth to our pre-wired load center box. At this point, your new Mardan guard booth is ready for immediate use.